|
Powder Coated Colored Screws
used on Roof and Sides:
Powder Coating the new standard
in painted finishes absolutely the finest, most durable, protective coating
in the fastener industry a technological advance that has changed the
industry:
 |
Outlasts any conventional spray
painted finish.
|
|
Powder painted finish lasts the
life of your panels. 40 Year Warranty
|
|
Powder coating process paints
under the fastener head where corrosion can start.
|
|
Powder Coated Tough Coating
over superior JS500 substrate exceeds 3000 Hours Salt Spray Life and
Leland exceeds 50 cycles in the SO˛ Kesternich Test with NO RED RUST !
|
|
NO CHIPPING, ABRASION
RESISTANT, NO PREMATURE FADING !
|
|
|
Screws attached in flat (vs.
ribbed) areas of steel panels:
|
Installing in the rib allows
movement around the critical seal area and that movement then compounds
the potential for leaks. |
|
Installing in the flat area is
a tighter, more secure method; there is no gap between steel and wood. |
|
A firm, lasting grip maximizes
seal effectiveness and strength. Structural integrity and leak resistance
are not compromised. |
|
 |
|
Expansion, contraction and wind
are constantly stressing the fasteners, “trying” to work them free. The
tight grip of a screw through the flat doesn’t give these forces any
leverage, thus preventing roof leaks and the reduction of building
strength. |
|
When a screw is attached to the
flat (instead of ribbed) area of a steel panel, a tighter connection is
assured. |
|
Since a post-frame building
gets much of its strength from the steel panels, the tighter it is
attached to the building, the better. Putting screws in the flat of the
steel panel provides the tightest and best possible connection. |
|
|
